Gordak 952 Service Manual

Gordak 952 (or 952A/952B) Service Manual

Here’s a sample forum-style post you can use or adapt when sharing or requesting the . The Gordak 952 is a popular 2-in-1 soldering iron + hot air rework station.

  • Where to find the manual:

    Pro Tip:

    If you search for "Schematic 858D hot air station" or "936 clone service manual," you will find 90% of what you need. The Gordak 952 uses the same AC heater control loop as the 858D. Gordak 952 Service Manual

    • Unpacking and Inspection: Carefully unpack and inspect the amplifier unit, ensuring all components are included and undamaged.
    • Mounting: Mount the amplifier unit in a well-ventilated area, ensuring adequate clearance for cooling.
    • Electrical Connections: Connect the amplifier to a suitable power source, ensuring correct voltage and frequency settings.
    • Output Connections: Connect the output load to the amplifier's output terminals.

    Safety Criticals

    : A vital "hidden" instruction in the manual is to remove the pump securing screw on the bottom of the machine before its first use; failure to do so can cause serious mechanical issues or excessive vibration . Gordak 952 (or 952A/952B) Service Manual Here’s a

    1. Turn off the unit. Open the main casing.
    2. Locate the trimpot labeled VR1 (for hot air) and VR2 (for soldering iron).
    3. Set the station to 400°C (hot air mode).
    4. Measure actual air temperature at the nozzle tip (hold probe 2cm away).
    5. Adjust VR1 slowly:

      Temperature Control

      : The station uses a microcomputer-controlled thermostatic system with dual LED displays for precise monitoring. If the temperature is unstable, check the feedback loop and the thermocouple inside the heating element. Component Replacement : Where to find the manual: Pro Tip: If