Narco Escort Ii Installation Manual |link| Full -
Narco Escort II
The is a legacy self-contained Nav/Com radio unit featuring a gas discharge display for frequencies and a row of lights for VOR/LOC "needle" deflection. This report summarizes the essential installation data found in available technical documentation. 1. System Overview Mounting: Designed for instrument panel mounting. Voltage: Operates on 14/28 V systems.
By following this installation manual, you'll be able to enjoy a seamless and enhanced entertainment experience on your boat or yacht. narco escort ii installation manual full
4.3 Wiring and Interconnections
The package arrived on a Tuesday, disguised as a set of high-end golf clubs. For Mateo, it was the culmination of three years of silence, savings, and swallowed pride. He carried the carbon-fiber case into his empty apartment, the echo of his footsteps a stark contrast to the thumping bass from the club downstairs. Narco Escort II The is a legacy self-contained
Intercom Setup
: An Intercom Key function is available via Pin 12. When this pin is externally grounded through a switch, the microphone audio bypasses the transmitter and is amplified for cabin use. 5. System Calibration and Testing Mount the tray in the instrument panel using
- Mount the tray in the instrument panel using the four #6-32 screws. Ensure the unit slides without binding.
- Fabricate the 26-pin harness using MIL-W-22759/16 wire (22 AWG for power, 24 AWG for signals).
- Crimp gold-plated pins (Amphenol 16-14 series) into the connector shell. Do not solder pins – Narco explicitly warns against solder wicking.
- Route power directly from the avionics bus via a 5-amp fuse or pull-type circuit breaker.
- Connect comm antenna coax to the BNC jack on the rear of the tray (labeled “ANT”).
- Drain the shield at one point only – the audio panel ground stud.