Sc569-00 Ricoh | 99% TRENDING |

SC569-00

The error code on a Ricoh device indicates a Fusing Pressure Release Motor Error . This is a hardware-level malfunction where the machine is unable to detect the correct position of the pressure rollers within the fusing unit. 🔍 Core Cause

Hardware Replacement

: If cleaning does not work, the One-Way Gear (D0BQ1375) or the Pressure Release Gear No. 3 (D1751377) may need to be replaced. How to Reset the SC Code

The Power Supply Unit (PSU) or the AC Drive Board generates the zero-cross signal. Fluctuating input voltage (dirty AC power, loose wall outlet, overloaded circuit) or failing capacitors on the PSU can corrupt this signal. sc569-00 ricoh

Connection Issues

: Loose wiring or poor contact between the fuser unit and the main body of the copier. Steps to Resolve SC569-00 1. Perform a Hard Reset

Once you resolve SC569-00, take these steps to prevent recurrence: SC569-00 The error code on a Ricoh device

3. Install the Latest Firmware

Service Mode Reset

: If the physical issue is resolved but the code persists, perform an SC Reset via the system service mode:

If you are seeing this code, you can try the following steps to clear it: Check for Paper Jams 3 (D1751377) may need to be replaced

Fusing Pressure Roller Lift Sensor:

This is often a U-shaped sensor that detects the position of the gears. Because it is located near the high-heat fuser unit, it is highly prone to failure.